ULV500 Fogger

Charge the unit:

If you have just received your CleanTite™ ULV500 Fogger, charge it for 6-8 hours to fully charge the lithium-ion battery.

Fill the tank:

Unscrew the clear plastic bottle and fill it with your preferred solution. Screw it tightly back onto the base of the unit.

Power up:

Locate the On/Off switch at the bottom back of the device. Slide the switch to the 'On' position and then press and hold the top 'M' button for 2 seconds to turn the unit on.

Adjust the pressure:

Choose from three different fog volume settings - low, medium, and high - by pressing the top 'M' button.

Apply in a sweeping motion:

The blue LED lights on the device indicate where the fog is being targeted. Apply the fog in a sweeping motion for complete coverage spaces or surfaces. To switch it off, double-tap the 'M' button.

Power down:

Move the bottom switch to the off position to turn off the CleanTite™ ULV500 Fogger.

Maintain your unit:

Empty any remaining solution and run warm soapy water through the device for 10 seconds. Follow this up with plain water to eliminate any soap residue. Regular maintenance helps to prevent clogging and ensures the longevity of your CleanTite™ ULV500 Fogger.

Make sure that the CleanTite™ ULV500 Fogger is properly plugged in and receiving power. Check the battery level and replace the batteries if necessary.

Ensure that there is enough fluid in the CleanTite™ ULV500 Fogger's tank. If the fluid level is low, refill the tank.

Verify that CleanTite™ ULV500 Fogger's settings are correct for your needs. If the fog output is too low or too high, adjust the settings accordingly.

If none of the above steps solve the issue, contact our customer service or technical support team for additional assistance.

First, ensure that you empty any leftover solution from the CleanTite™ ULV500 Fogger tank.

Fill the tank with warm soapy water and run the CleanTite™ ULV500 Fogger for about 10 seconds. This step will clear out any debris that may have accumulated inside the device.

After using the soapy water, fill the tank with plain water and run the CleanTite™ ULV500 Fogger to flush out any remaining soap residue.

Fill the fluid tank with water and a few drops of dish soap. Do not overfill the tank.

Turn on the ULV500 Fogger and allow it to warm up for several minutes. This will give the soapy water enough time to heat up and start to produce fog.

To prime the ULV500 Fogger, press and hold the "M" button or switch for several seconds. This will force the fog fluid through the heating element. Just like the cleaning process, after the soapy water solution runs through the unit, refill with just water and run that through as well. Now your atomizer fogger is ready to fog your desired solution.